蓝藻资源化技术研究及应用进展

针对蓝藻资源化问题,概述国内外利用蓝藻制备有机肥、提取高纯度藻蓝蛋白、制备活性炭和藻粉这4种利用方式的特点、现状及应用进展。提出,应从高温好氧堆肥技术、藻蓝蛋白提取技术和藻水分离技术这3个方面,解决其关键技术问题并进行进一步研究开发。     

高黏度污泥螺带螺杆搅拌混合特性的数值模拟

污泥处理过程通常需要加入添加剂,而高黏度污泥流动性差,搅拌混合是一个难点。选用螺带螺杆搅拌器加添加剂搅拌高黏度污泥,用Solid Works软件几何建模后,将模型导入Gambit划分网格,结合Fluent软件选用多重参考系法(MRF)分别对双螺带螺杆搅拌器与单螺带螺杆搅拌器下的污泥与添加剂混合过程进行了模拟,对比了两种搅拌桨的混合时间、体积分数流场分布及混合效率,分析了不同加料区域的影响,并将搅拌功率模拟与试验结果进行了对比。结果表明:螺带螺杆搅拌器适用于高黏度污泥的搅拌且双螺带螺杆搅拌器混合时间更短,体积分数流场更快趋于稳定且混合效率更高;最佳加料区域为搅拌槽的中部。     

彗星试验技术在水生与土壤环境中的毒理学应用

彗星试验是一种检测真核细胞脱氧核糖核酸(DNA)损伤的技术,快速、低成本、适用于几乎所有真核细胞,因此常应用于遗传毒理学、辐射生物学、肿瘤细胞学、毒性检测等方面。尤其以灵敏度高、检测联合毒性的特点大量运用于环境研究中。主要介绍彗星试验方法学发展历程,彗星试验的原理及其在环境领域中的应用,并指出应用中的受限因素以及未来的发展前景,为今后进一步推广该试验技术提供理论上的指导与参考。     

活化后钾改性正硅酸锂吸附CO2的性能评价及动力学研究

制备了钾改性正硅酸锂(K-Li4SiO4),并对其进行了自活化,考察了活化后K-Li4SiO4吸附剂在不同温度和CO2浓度气氛中吸附CO2的性能及动力学行为。总体而言,吸附剂的CO2吸附能力随着温度的升高、CO2浓度的增加而提升。在700℃、100%体积分数CO2气氛中吸附剂的吸附量最大,可达7.9 mmol/g,吸附剂的利用率为95.2%。利用双指数模型能够很好地描述吸附剂在各个温度以及各个CO2浓度气氛下的CO2吸附过程。吸附活化能随着CO2气氛浓度的升高而降低,CO2体积分数为20%,50%,100%时的吸附活化能分别为26448,14035,6178 J/mol。     

Seasonal variations of monocarbonyl and dicarbonyl in urban and sub-urban sites of Xi’an,China

Seventeen airborne carbonyls including monocarbonyls and dicarbonyls were determined in urban and sub-urban sites of Xi’an, China in three seasons in 2010. In winter, acetone was the most abundant carbonyl in the urban site due to usage of organic solvents in constructions and laboratories and its slower atmospheric removal mechanisms by photolysis and reaction with hydroxyl radical than those of formaldehyde and acetaldehyde. In the sub-urban site, acetaldehyde was the most abundant carbonyl, followed by formaldehyde and acetone. During summer, however, formaldehyde was the most dominant carbonyl in both sites. The photooxidations of a wide range of volatile organic compounds (VOCs) yielded much more formaldehyde than other carbonyls under high solar radiation and temperature. In the urban site, the average concentrations of dicarbonyls (i.e., glyoxal and methyglyoxal) in spring and summer were higher than that in winter. Transformation of aromatic VOCs emitted from fuel evaporation leads to the formation of 1,2-dicarbonyls. A reverse trend was observed in sub-urban sites, as explained by the relatively low abundances and accumulations of VOC precursors in the rural atmosphere during warm seasons. Moreover, cumulative cancer risk based on measured outdoor carbonyls (formaldehyde and acetaldehyde) in Xi’an Jiaotong University and Heihe was estimated (8.82?×?10^?5 and 4.96?×?10^?5, respectively). This study provides a clear map on the abundances of carbonyls and their source interpretation in the largest and the most economic city in Northwestern China.     

我国大气中挥发性有机物的分布特征

大气中挥发性有机物(VOCs)是臭氧和二次有机气溶胶形成的关键前体物之一,研究表明烷烃、烯烃、芳香烃是我国大气VOCs的重要组分。在不同区域,城市地区烷烃含量最高,而偏远地区芳香烃为含量最丰富的VOCs。VOCs浓度日间变化多呈双峰分布趋势,峰值多出现在早晨与傍晚的上下班高峰期。目前对我国臭氧污染事件的研究均表明芳香烃和烯烃是对臭氧生成贡献最大的化合物。VOCs源解析中广泛运用的模型包括CMB、PMF和PCA/APCS,各模型均存在优点和局限性。比较各地VOCs源解析结果,发现交通排放源和工业排放源为我国VOCs的主要人为来源。VOCs的跨区域传输决定与周边地区的合作将是未来空气治理中的发展方向。     

西安市重污染与清洁天PM2.5组分及其活性氧物质对比

针对重霾污染,在西安市冬季重污染日(2015-11-30~2015-12-09)和清洁日(2016-01-13~2016-01-22)各进行了为期10d的PM_(2.5)采集,测量其中的有机碳、元素碳,及NH_4~+、NO_3~-、SO_4~(2-)等无机水溶性离子,探讨两种污染条件下的组分特征及其成因.结果表明:观测期,重霾日和清洁日PM_(2.5)质量浓度分别为(170±47.5)μg·m~(-3)和(48.6±17.9)μg·m~(-3),且重霾日伴随低能见度、高湿静风等多种不利气象条件;重霾日二次无机离子(NH_4~+、NO_3~-、SO_4~(2-))组分占PM_(2.5)质量浓度的49.8%±13.1%,而清洁日为19.4%±5.95%,并且重霾日硫氧化速率(sulfur oxidation ratio,SOR)和氮氧化速率(nitrogen oxidation ratio,NOR)分别为0.282±0.157和0.269±0.124,远高于清洁日(SOR和NOR分别为0.189±0.057和0.077±0.046),重霾日二次有机组分浓度[(6.22±3.87)μg·m~(-3)]是清洁日[(1.44±1.63)μg·m~(-3)]的5倍,表明二次污染及不利气象条件是造成重霾期间相关组分浓度升高的重要原因.最后,通过二氯荧光黄双乙酸盐(2',7'-DCFH)化学荧光分析法测定了其中活性氧物质(reactive oxygen species,ROS)的浓度,探讨其对于二次无机组分形成的影响,结果表明观测期ROS平均浓度(以H_2O_2计)分别为(4.99±1.54)nmol·m~(-3)(重霾期),(0.492±0.356)nmol·m~(-3)(清洁期),二次反应及积累效应可能是西安重霾条件下ROS浓度升高的主要原因.NO_3~-、SO_4~(2-)与ROS均呈现正相关(P0.05),表明ROS可能通过二次氧化过程参与到二次无机组分形成过程中.     

Ag-AgI/CN/MA复合物的制备及其可见光催化性能

采用沉淀法和热聚合法分别将AgI、氮化碳(CN)负载在介孔γ-Al_2O_3(MA)上,并通过光还原银离子成功制备了等离子体诱导可见光催化剂Ag-AgI/CN/MA.利用X射线衍射(XRD)、X射线光电子能谱(XPS)、场发射扫描电子显微镜(FESEM)、紫外可见漫反射光谱(UV-vis DRS)和透射电子显微镜(TEM)对Ag-AgI/CN/MA复合材料进行表征,并对其在可见光照射下(λ420 nm)的光催化性能进行了研究,考察了初始溶液pH值及催化剂投加量等条件对光催化反应的影响.结果表明,表面银以Ag+和Ag0形式共存,并且Ag和AgI均匀地分散在CN的表面.与CN和Ag-AgI/MA相比,Ag-AgI/CN/MA复合物对甲基橙(MO)具有更高的可见光催化降解效率,且反应过程中Ag+的释放量显著减少,显示出良好的稳定性.当溶液pH值为7、催化剂投加量为1 g·L~(-1)时,Ag-AgI/CN/MA-2显示出最优的催化性能.同时,其对罗丹明B(Rh B)、甲基红(MR)和刚果红(CR)等不同电性的染料均体现出良好的催化性能.     

Carbonyl emissions from vehicular exhausts sources in Hong Kong

Vehicular emission (VE) is one of the important anthropogenic sources for airborne carbonyls in urban area. Six types of VE-dominated samples were collected at representative locations in Hong Kong where polluted by a particular fueled type of vehicles, including (i) a gas refilling taxis station (liquefied petroleum gas [LPG] emission); (ii) a light-duty passenger car park (gasoline emission); (iii) a minibus station (diesel emission); (iv) a single-deck-bus depot (diesel emission); (v) a double-deck-bus depot (diesel emission); and (vi) a whole-food market entrance for light- and heavy-duty vehicles (diesel emission). A total of 15 carbonyls in the samples were quantified. Formaldehyde was the most abundant carbonyl among the VE-dominated samples, and its contribution to the total quantified amount on a molar basis ranged from 54.8% to 60.8%. Acetaldehyde and acetone were the next two abundant carbonyls. The carbonyls were quantified at three roadside locations in Hong Kong. The highest concentrations of formaldehyde and acetaldehyde, 22.7 +/- 8.4 and 6.0 +/- 2.8 microg/m3, respectively, were determined in the samples collected at a main transportation gate for goods between Hong Kong and Mainland China. The total quantified carbonyl concentration, 37.9 +/- 9.3 microg/m3, was the highest at an entrance of a cross-harbor tunnel in downtown area. The theoretical carbonyls compositions of the three roadside locations were estimated according to the VE-dominated sample profiles and the statistics on vehicle numbers and types during the sampling period. The measured compositions of formaldehyde were much higher than the theoretical compositions in summer, demonstrating that photochemical reactions significantly contributed to the formaldehyde production in the roadsides.